The actual physical process of building a PC is more forgiving than people expect, screws only go where they fit, and connectors are keyed so you generally can't plug things in backwards. Where people actually get stuck is almost always in the planning stage, before a single screw goes in.

Buying parts that don't match sockets

CPU and motherboard socket must match exactly. This sounds obvious written down, but it's the single most common return reason for first-time builders, usually because they bought each part from a different bargain listing without cross-checking. Pick your CPU and motherboard together, always.

Forgetting the memory type

DDR4 and DDR5 memory are physically different and not interchangeable. Your motherboard supports one or the other, never both. Check this before buying RAM, not after it arrives and doesn't fit the slots.

Underestimating the power supply

Covered in detail in our power supply guide, but the short version: check your total system's estimated wattage against the PSU's rated output before you buy, with some headroom. Running a system right at the edge of a power supply's capacity is a common cause of random shutdowns under load.

Not checking case clearance

Graphics card length and CPU cooler height both need checking against your specific case. Discovering a graphics card doesn't fit after everything else is already installed is one of the most deflating moments in a first build.

Skipping the I/O shield or standoffs

Small, easy to miss, and awkward to fix after the motherboard is screwed in. The I/O shield (the metal plate around the rear ports) goes in before the motherboard, not after. Standoffs (the small brass screws that lift the motherboard off the case) need to match your motherboard's mounting holes exactly, extra standoffs can short the board.

Not updating the BIOS before installing a new CPU generation

If you've bought a recently released CPU and an older motherboard revision, it may need a BIOS update before it'll even POST. Some motherboard manufacturers offer a "boot flashback" feature that lets you update the BIOS without a working CPU installed, using just a USB stick and the board's standby power. Check whether your board supports this before you're stuck with a CPU that won't boot on arrival.

Building on carpet

Static discharge risk. Build on a hard floor or table if you can, and touch the case's bare metal chassis before handling components to discharge any static from yourself first.